CRUISE CONTROL MAIN SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A00K02Q

      Detach the 2 claws and remove the cover.

  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A00JWFXE01
      Text in Illustration
      *A w/o Cruise Control System
      *B w/ Cruise Control System

      Detach the 2 claws and remove the cover.

  4. REMOVE STEERING PAD


    1. A00JZQKE01
      Text in Illustration
      *1 Screw Case

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A00JVTP

      Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the 2 connectors and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  5. REMOVE CRUISE CONTROL MAIN SWITCH


    1. A00OA8L

      Disconnect the connector.

    2. Remove the 2 screws and switch.