STARTER (for 2.0 kW Type) INSTALLATION


  1. INSTALL STARTER ASSEMBLY


    1. for Automatic Transmission:

      Install the starter with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. for Manual Transmission:


      1. Temporarily install the starter with bolt.

      2. A0095CUE01
        Text in Illustration
        *1 Clutch Flexible Hose Bracket

        Temporarily install the clutch flexible hose bracket with the bolt.

      3. Tighten the 2 bolts.

        Torque:
        37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Connect the starter connector.

    4. Connect the starter wire harness with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Install the terminal cap.

  2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

    A00K0C4

    1. Coat a new O-ring with ATF, and install it to the oil filler tube.

    2. Install the oil filler tube to the transmission with the 2 bolts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    3. Install the oil dipstick.

  3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)


    1. Connect the clutch release cylinder with the 2 bolts.

      Torque:
      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

  4. INSTALL REAR ENGINE UNDER COVER ASSEMBLY


    1. Install the rear engine under cover with the 4 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.