OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not let adhesive adhere to the oil hole.

    2. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

    3. Connect the oil pressure switch connector.

  2. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  3. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes.

    2. Check that the oil level is between the dipstick low level mark and full level mark.

      If the level is low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.

  4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A00O712

      Hook the engine under cover to the vehicle body as shown in the illustration.

    2. Install the 4 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  5. INSTALL FRONT BUMPER COVER LOWER


    1. Install the front bumper cover lower with the 5 bolts and clip.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }