OIL PRESSURE SWITCHING VALVE INSTALLATION


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY


    1. Apply a light coat of engine oil to the O-ring of the oil pressure switching valve.

    2. Install the oil pressure switching valve with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the valve.

    3. Connect the oil pressure switching valve connector.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Item Oil Grade Oil Viscosity (SAE)
      w/ DPF

      ACEA C2

      (Using engine oil other than ACEA C2 may damage catalytic converter)

      - 0W-30

      - 5W-30

      (0W-30 is best choice for fuel economy and good starting in cold weather)
      w/o DPF

      G-DLD1, API CF-4, CF or ACEA B1

      (You may also use API CE or CD)

      - 5W-30

      - 10W-30

      - 15W-40

      - 20W-50
      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 6.7 liters (7.1 US qts, 5.9 Imp. qts)
      Drain and refill with oil filter change 7.0 liters (7.4 US qts, 6.2 Imp. qts)
      Dry fill 7.5 liters (7.9 US qts, 6.6 Imp. qts)

    2. Install the oil filler cap.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. Install the No. 1 engine under cover with the 4 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  5. INSTALL FRONT BUMPER LOWER COVER


    1. Install the front bumper lower cover with the clip and 5 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }