OIL PRESSURE SENSOR INSTALLATION


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the engine oil pressure sender gauge connector.

  2. ADD ENGINE OIL

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.