ENGINE OIL COOLER REMOVAL


  1. REMOVE GENERATOR ASSEMBLY


    1. Remove the generator Click here.

  2. REMOVE EXHAUST MANIFOLD


    1. Remove the exhaust manifold Click here.

  3. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

      A0094ULE01
      Text in Illustration
      *1 Radiator Cap *2 Radiator Reservoir
      *3 Radiator Drain Cock Plug *4 Cylinder Block Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Drain the coolant by removing the radiator cap.

    3. Loosen the cylinder block drain cock plug.

    4. Loosen the cylinder block drain cock plug and drain the coolant from the engine.

      Note

      If coolant is not drained from the radiator drain cock plug, cylinder block drain cock plugs and radiator reservoir, clogging in the radiator or coolant leakage from the seal of the water pump may result.

  4. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil drain plug and gasket, and then drain the oil into a container.

    3. Clean the drain plug and install it with a new gasket.

      Torque:
      35 N*m  { 352 kgf*cm, 25 ft.*lbf }

  5. DISCONNECT OIL FILTER SUB-ASSEMBLY


    1. A00JZR7E01

      Using SST, remove the oil filter.

      SST
      09228-44011

  6. DISCONNECT VACUUM PUMP OIL INLET HOSE


    1. A00JWVQ

      Remove the union bolt and gasket, and then disconnect the vacuum pump oil inlet hose from the cylinder block.

  7. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY


    1. A00JUOB

      Remove the 10 bolts, 2 nuts, oil filter bracket and gasket.

  8. REMOVE OIL COOLER ASSEMBLY


    1. Remove the 4 nuts, oil cooler and 2 gaskets.