FRONT DOOR BELT MOULDING REMOVAL

REMOVE DOOR SIDE AIRBAG SENSOR

1. Check that the ignition switch is off.

2. Check that the cable is disconnected from the negative (-) battery terminal.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Disconnect the connector from the door side airbag sensor.

   Note

   When disconnecting any airbag connector, take care not to damage the airbag wire harness.

   1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

      

      Text in Illustration

      *1	White Housing Lock	*2	Yellow CPA
      *a	Connector Lock is Released	-	-

   2. Push down the white housing lock again and disconnect the connector.

      Note

      Do not push down the part (A) shown in the illustration when disconnecting.

4. Remove the bolt and door side airbag sensor from the front door panel.

   

   Note

   Loosen the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.

5. After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

   

   Text in Illustration

   *a

   Incorrect

   *b

   Correct

REMOVE FRONT DOOR SERVICE HOLE COVER

1. Remove the bolt.

   

2. Disconnect each connector.

3. Disengage the 5 clamps.

4. Remove the front door service hole cover.

   Tech Tips

   Remove any remaining butyl tape from the door.

REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

1. Remove the grommet.

   

2. Connect the cable to the negative (-) battery terminal.

3. Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

4. Disconnect the cable from the negative (-) battery terminal.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. Disconnect the power window regulator master switch assembly.

6. Remove the 2 bolts.

   

   Note

   After the bolts are removed, do not allow the door glass to fall.

7. Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.

   

   Note

   Do not damage the door glass.