REAR BUMPER REASSEMBLY

  1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

    1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

      A011RRG
      Torque:
      61 N*m  { 622 kgf*cm, 45 ft.*lbf }

  2. INSTALL REAR BUMPER ENERGY ABSORBER

    1. Engage the 2 guides to install the rear bumper energy absorber.

      A011TZK

  3. INSTALL WHEEL HOUSE REINFORCEMENT LH

    1. Install the wheel house reinforcement LH with the screw and nut.

      A011TKC

    2. Engage the clip.

  4. INSTALL WHEEL HOUSE REINFORCEMENT RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. INSTALL REAR BUMPER SIDE RETAINER LH

    1. Engage the 6 claws.

      A011SJD

    2. Install the rear bumper side retainer LH with the 3 screws.

  6. INSTALL REAR BUMPER SIDE RETAINER RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)

    1. Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.

      A011VARE01
      Text in Illustration
      *A LH Side
      *B Other Side
      *a Keyhole
      *b Snap

      Note

      • Do not damage the front bumper with the protrusion when installing the retainer.

      • Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

      Tech Tips

      When installing the retainer, align the keyhole and snap as shown in the illustration.

  8. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)

    1. Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

      A011THYE01
      Text in Illustration
      *A LH Side
      *B Other Side

      Note

      Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

  9. INSTALL ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System)

    1. Engage the 4 claws to install the ultrasonic sensor clip.

      A011RTFE01
      Text in Illustration
      *A LH Side
      *B Other Side

    2. Engage the clamp.

      A011V07E01
      Text in Illustration
      *A LH Side
      *B Other Side

    3. Connect the connector.

  10. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System)

    1. Connect the 4 connectors.

      A011TXX

    2. Engage the 4 clamps to install the No. 2 luggage room wire.