WIPER AND WASHER SYSTEM PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:

    System See Procedure
    Parking Assist Monitor System

    Click here

  2. IGNITION SWITCH EXPRESSIONS

    The type of ignition switch used on this model differs according to the specification of the vehicle.

    The expressions listed in the table below are used in this section.

    Expression Ignition Switch (Position) Engine Switch (Condition)
    Ignition Switch off LOCK Off
    Ignition Switch ACC ACC On (ACC)
    Ignition Switch ON ON On (IG)
    Engine Start START Start

  3. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

    1. Do not clean or adjust the washer nozzle with a safety pin, etc. because;

      1. the washer nozzle tip is made of resin and could be damaged.

      2. adjustment is not necessary because the washer nozzle is a spray type. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle. Click here

    2. If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush, etc.