OUTER REAR VIEW MIRROR INSTALLATION

Tech Tips

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

    1. Engage the claw to temporarily install the outer rear view mirror assembly.

    2. Install the outer rear view mirror assembly with the 3 bolts.

      Torque:
      11 N*m  { 107 kgf*cm, 8 ft.*lbf }

    3. Connect the connector.

  2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    1. Install the front door inner glass weatherstrip.

      A011TAM

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

      A011TQME01
      Text in Illustration
      *1 Front Door Inside Locking Cable Assembly
      *2 Front Door Lock Remote Control Cable Assembly

    2. Engage the front door trim board sub-assembly with the 4 claws and reference boss as shown in the illustration.

      A011SQHE01
      Text in Illustration
      *1 Reference Boss

    3. Engage the 10 clips and install to front door trim board sub-assembly.

      A011RIN

    4. Install the 3 screws.

    5. If protective tape has been applied, remove it.

  4. INSTALL COURTESY LIGHT ASSEMBLY

    1. Connect the connector.

    2. Engage the claw to install the courtesy light assembly.

      A011TI7E01
      Text in Illustration
      *A for LH Side
      *B for RH Side

  5. INSTALL FRONT ARMREST ASSEMBLY

    1. Engage the 2 guides, 3 clips and 7 claws, and install the front armrest assembly.

      A011SU2

  6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    1. Connect each connector.

    2. Engage the 4 guides, 2 clips and 5 claws, and install the power window regulator master switch assembly with front door armrest base panel.

      A011QZ8

  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    1. Connect each connector.

    2. Engage the 4 guides, 2 clips and 5 claws, and install the power window regulator switch assembly with front door armrest base panel.

      A011UWR

  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    1. Engage the 3 clips to install the front door lower frame bracket garnish.

      A011SPW

  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    1. Engage the 3 claws to install the front door inside handle bezel plug.

      A011RPH