OUTER REAR VIEW MIRROR DISASSEMBLY

Tech Tips

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

  1. REMOVE OUTER REAR VIEW MIRROR (w/o Retract Mirror)

    1. Apply protective tape to the areas shown in the illustration.

      A011RVHE01
      Text in Illustration
      *1 Protective Tape

    2. Push the lower part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror as shown in the illustration.

      A011TVOE01
      Text in Illustration
      *1 Moulding Remover

    4. Disengage the 2 guides and remove the outer rear view mirror as shown in the illustration.

      A011T6W

    5. w/ Mirror Heater:

      1. Disconnect the 2 connectors and remove the outer rear view mirror.

        A011QWY

    6. w/ Mirror Heater and Blind Spot Monitor System:

      1. Disconnect the 2 mirror heater connectors.

      2. Disengage the 2 claws.

      3. Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer rear view mirror.

        A011TQHE01
        Text in Illustration
        *1 Mirror Heater Connector
        *2 Blind Spot Monitor Indicator Connector

        Note

        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer rear view mirror with a new one.

  2. REMOVE OUTER REAR VIEW MIRROR (w/ Retract Mirror)

    1. Apply protective tape to the areas shown in the illustration.

      A011SYHE01
      Text in Illustration
      *1 Protective Tape

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror as shown in the illustration.

      A011V64E01
      Text in Illustration
      *1 Moulding Remover

    4. Disengage the 2 guides as shown in the illustration.

      A011RM6

    5. Disconnect the 2 connectors and remove the outer rear view mirror.

      A011V48

  3. REMOVE OUTER MIRROR COVER (w/o Retract Mirror)

    1. Disengage the 8 claws and remove the outer mirror cover.

      A011UFJ

  4. REMOVE OUTER MIRROR COVER (w/ Retract Mirror)

    1. Remove the 3 screws.

      A011UXN

    2. Disengage the clamp.

      A011UWK

    3. Disconnect the 2 connectors and remove the mirror actuator.

    4. Disengage the 7 claws and remove the outer mirror cover.

      A011T8C

  5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (w/ Retract Mirror)

    1. Disengage the 2 claws.

      A011RIH

    2. Disconnect the connector and remove the side turn signal light assembly.