OUTER REAR VIEW MIRROR REMOVAL

Tech Tips

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    1. Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug as shown in the illustration.

      A011TFX

  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    1. Disengage the 3 clips and remove the front door lower frame bracket garnish.

      A011SPW

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    1. Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

      A011T0T

    2. Disconnect each connector and remove the power window regulator master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    1. Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

      A011SBP

    2. Disconnect each connector and remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE FRONT ARMREST ASSEMBLY

    1. Using a moulding remover, disengage the 3 clips, 7 claws and 2 guides and remove the front armrest assembly.

      A011R4P

  6. REMOVE COURTESY LIGHT ASSEMBLY

    1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

      A011V2JE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    1. Put protective tape around the front door panel.

      A011U78E01
      Text in Illustration
      *1 Protective Tape

    2. Remove the 3 screws.

      A011RIN

    3. Using a clip remover, disengage the 10 clips.

    4. Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

      A011RTVE01
      Text in Illustration
      *1 Reference Boss
      *2 Front Door Inner Glass Weatherstrip

    5. Disengage the reference boss from the front door panel.

    6. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    7. Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

      A011U35

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    1. Using a screwdriver, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

      A011UI0E01
      Text in Illustration
      *1 Screwdriver

  9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

    1. Disconnect the connector.

      A011T6O

    2. Remove the 3 bolts.

    3. Disengage the claw and remove the outer rear view mirror assembly.