LUGGAGE COMPARTMENT DOOR ADJUSTMENT

A011RFIE01
Text in Illustration
*1 Centering Bolt
*2 Standard Bolt

Tech Tips

  • Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • Specified torque for standard bolts is shown in the standard bolt chart Click here.

  1. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    1. Remove the 13 clips and luggage compartment door cover.

      A011TF6

  2. REMOVE SPARE WHEEL COVER ASSEMBLY

    1. Remove the spare wheel cover assembly.

  3. REMOVE BAGGAGE HOLDER NET (w/ Partition Net)

    1. Remove the baggage holder net.

  4. REMOVE REAR FLOOR FINISH PLATE

    1. Remove the 5 clips.

      A011SS8

    2. Disengage the 4 clips and remove the rear floor finish plate.

      A011R0B

  5. ADJUST LUGGAGE COMPARTMENT DOOR

    1. Loosen the door side hinge bolts to adjust the door horizontally and vertically.

      A011U7S
      Torque:
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }

    2. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

      A011SXI

    3. Using a brass bar and a hammer, hit the striker to adjust its position.

    4. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

  6. INSTALL REAR FLOOR FINISH PLATE

    1. Engage the 4 clips and install the rear floor finish plate.

      A011S9G

    2. Install the 5 clips.

  7. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)

    1. Install the baggage holder net.

  8. INSTALL SPARE WHEEL COVER ASSEMBLY

    1. Install the spare wheel cover assembly.

  9. INSTALL LUGGAGE COMPARTMENT DOOR COVER

    1. Install the luggage compartment door cover with the 13 clips.

      A011TF6

  10. INSPECT LUGGAGE COMPARTMENT DOOR

    1. Check that the clearance measurements of areas a through d are within each standard range.

      A011UBVE01
      Standard Clearance
      Area Measurement Area Measurement
      a 6.4 mm (0.252 in.) b 2.0 to 5.0 mm (0.0787 to 0.197 in.)
      c -1.0 to 2.0 mm (-0.0394 to 0.0787 in.) d 3.85 to 7.85 mm (0.152 to 0.309 in.)