SLIDING ROOF SWITCH ASSEMBLY INSPECTION

  1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)

    1. Measure the resistance according to the value(s) in the table below.

      A011V81E01
      Standard Resistance
      Tester Connection Condition Specified Condition
      5 (UP) - 1 (GND) UP switch is pressed Below 1 Ω
      5 (UP) - 1 (GND) UP switch is not pressed 10 kΩ or higher
      4 (DOWN) - 1 (GND) DOWN switch is pressed Below 1 Ω
      4 (DOWN) - 1 (GND) DOWN switch is not pressed 10 kΩ or higher
      3 (OPN) - 1 (GND) OPEN switch is pressed Below 1 Ω
      3 (OPN) - 1 (GND) OPEN switch is not pressed 10 kΩ or higher
      2 (CLS) - 1 (GND) CLOSE switch is pressed Below 1 Ω
      2 (CLS) - 1 (GND) CLOSE switch is not pressed 10 kΩ or higher
      Text in Illustration
      *a

      Component without harness connected

      (Sliding Roof Switch (Roof Console Box Assembly))

      If the result is not as specified, replace the sliding roof switch (roof console box assembly).