POWER WINDOW REGULATOR MOTOR (for Front Door) INSPECTION

  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    1. Apply positive (+) battery voltage to connector terminal 2 (B).

      A011UEYE18

      Note

      Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

    2. Connect a negative (-) battery to connector terminals 1 (E) and 7 (DWN1) or 10 (UP1).

    3. Check that the motor gear rotates smoothly as follows:

      OK
      Measurement Condition Specified Condition

      1. Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (E), and keep them connected for 3 seconds or more.

      2. With terminals 2 (B) and 1 (E) connected, connect a negative (-) battery lead to terminal 10 (UP1).

      3. Disconnect and reconnect the negative (-) battery lead for terminal 10 (UP1) within 1 second.

      		 Motor gear rotates clockwise

      1. Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (E), and keep them connected for 3 seconds or more.

      2. With terminals 2 (B) and 1 (E) connected, connect a negative (-) battery lead to terminal 7 (DWN1).

      3. Disconnect and reconnect the negative (-) battery lead for terminal 7 (DWN1) within 1 second.

      		 Motor gear rotates counterclockwise
      Text in Illustration
      *a

      Component without harness connected

      (Power Window Regulator Motor Assembly LH)
      *b Counterclockwise
      *c Clockwise

      • If the result is not as specified, replace the power window regulator motor assembly LH.

      Note

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

    1. Apply battery voltage to the motor connector according to the table below.

      A011TV3E07

      Note

      Do not apply battery voltage to any terminals except terminals 1 and 2.

      Standard
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 1

      Battery negative (-) → Terminal 2

      		 Motor gear rotates clockwise

      Battery positive (+) → Terminal 2

      Battery negative (-) → Terminal 1

      		 Motor gear rotates counterclockwise
      Text in Illustration
      *a

      Component without harness connected

      (Power Window Regulator Motor Assembly RH)
      *b Motor Gear
      *c Clockwise
      *d Counterclockwise

      If the result is not as specified, replace the power window regulator motor assembly RH.