FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE

    1. Disengage the 10 claws and remove the front door scuff plate LH.

      A011RIY

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE REAR DOOR SCUFF PLATE

    1. Disengage the 6 claws and remove the rear door scuff plate LH.

      A011RO9

      Tech Tips

      Disengage the claws from the rear side of the scuff plate.

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

    1. Disconnect the rear door opening trim weatherstrip.

  7. REMOVE LAP BELT OUTER ANCHOR COVER

    1. Disengage the 3 claws and remove the lap belt outer anchor cover.

      A011UT6

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    1. Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.

      A011STL

  9. REMOVE CENTER PILLAR LOWER GARNISH

    1. Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.

      A011T7N

  10. REMOVE CENTER PILLAR UPPER GARNISH

    1. Remove the 2 screws.

      A011U1C

    2. Disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

      A011USP

    2. Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      A011V69E01
      Text in Illustration
      *1 Protective Tape

      Tech Tips

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts and front seat outer belt assembly.

      A011SS2

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    1. Remove the 2 bolts.

      A011T3V

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.