FRONT SEAT ASSEMBLY (for TMMK Made Power Seat) INSTALLATION

  1. INSTALL FRONT SEAT ASSEMBLY

    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector and clamp under the seat.

    3. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    6. Tighten the 2 bolts on the front side of the seat.

      A011UB5E01
      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

    7. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

    8. Tighten the 2 bolts on the rear side of the seat.

      A011SG5E01
      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

  2. INSTALL REAR INNER SEAT TRACK BRACKET COVER

    1. Engage the 2 claws to install the rear inner seat track bracket cover.

  3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER

    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  4. INSTALL FRONT SEAT HEADREST ASSEMBLY

  5. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)

    Click here

  6. INSPECT FRONT SEAT ASSEMBLY

    1. Check the power seat operation Click here.

    2. w/ Seat Heater System:

      Check the seat heater operation.

      1. Turn the ignition switch to ON.

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  7. INSPECT SRS WARNING LIGHT

    Click here