OCCUPANT CLASSIFICATION ECU INSTALLATION

INSTALL OCCUPANT DETECTION ECU
1. Engage the claw to install the occupant detection ECU.
  
  Note
  
  If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
2. Connect the 2 connectors.
  
  Note
  
  When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.
INSTALL FRONT SEAT ASSEMBLY RH
Tech Tips

Use the same procedure for the RH side and LH side.
- for TMMK Made Manual Seat: Click here
- for SIA Made Manual Seat: Click here
- for TMMK Made Power Seat: Click here
- for SIA Made Power Seat: Click here
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here
PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

Click here