SEAT HEATER SWITCH INSPECTION

  1. INSPECT SEAT HEATER SWITCH (for LH)

    1. Check the seat heater switch.

      1. Measure the resistance according to the value(s) in the table below.

        A011RYGE01
        Text in Illustration
        *a

        Component without harness connected

        (Seat Heater Switch (for LH))
        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        8 - 6 OFF 10 kΩ or higher
        8 - 6 ON 350 Ω to 3.4 kΩ
        8 - 3 ON Below 1 Ω

        If the result is not as specified, replace the seat heater switch (for LH).

    2. Check that the LED illuminates.

      1. Apply battery voltage to the seat heater switch (for LH) and check that the LED illuminates.

        A011RYGE01
        Text in Illustration
        *a

        Component without harness connected

        (Seat Heater Switch (for LH))
        OK
        Measurement Condition Switch Condition Specified Condition

        Battery positive (+) → Terminal 7

        Battery negative (-) → Terminal 2

        		 - LED illuminates

        Battery positive (+) → Terminal 8

        Battery negative (-) → Terminal 4

        		 ON

        If the result is not as specified, replace the seat heater switch (for LH).

  2. INSPECT SEAT HEATER SWITCH (for RH)

    1. Check the seat heater switch.

      1. Measure the resistance according to the value(s) in the table below.

        A011RYGE01
        Text in Illustration
        *a

        Component without harness connected

        (Seat Heater Switch (for RH))
        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        7 - 5 OFF 10 kΩ or higher
        7 - 5 ON 350 Ω to 3.4 kΩ
        7 - 2 ON Below 1 Ω

        If the result is not as specified, replace the seat heater switch (for RH).

    2. Check that the LED illuminates.

      1. Apply battery voltage to the seat heater switch (for RH) and check that the LED illuminates.

        A011RYGE01
        Text in Illustration
        *a

        Component without harness connected

        (Seat Heater Switch (for RH))
        OK
        Measurement Condition Switch Condition Specified Condition

        Battery positive (+) → Terminal 6

        Battery negative (-) → Terminal 1

        		 - LED illuminates

        Battery positive (+) → Terminal 7

        Battery negative (-) → Terminal 3

        		 ON

        If the result is not as specified, replace the seat heater switch (for RH).