KNEE AIRBAG ASSEMBLY (for Front Passenger Side) INSTALLATION

  1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

      A011TQFE01

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

    4. Push in the lock to install the airbag connector.

    5. Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    1. Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  3. INSTALL INSTRUMENT SIDE PANEL RH

    1. Engage the 3 guides.

    2. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.

      A011RD8

  4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. INSPECT SRS WARNING LIGHT

    Click here