CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

PRECAUTION

REMOVE ROOF HEADLINING ASSEMBLY

Click here

REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

1. Check that the ignition switch is off.

2. Check that the cable is disconnected from the negative (-) battery terminal.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

   

   Text in Illustration

   *1	Protective Tape
   *2	Airbag Connector
   *3	Airbag Connector Lock

   Note

   When disconnecting any airbag connector, take care not to damage the airbag wire harness.

4. Using a clip remover, remove the pin.

   

   Tech Tips

   Perform the same procedure for the other pins.

5. Using 2 screw drivers, disengage the 2 claws and remove the clip from the body panel as shown in the illustration.

   

   Text in Illustration

   *1

   Body Panel

   *2

   Curtain Shield Airbag Assembly

   Tech Tips

   Perform the same procedure for the other clips.

6. While holding the curtain shield airbag assembly, disengage the 5 claws.

   

   Note

   When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

7. Remove the 2 bolts.

   

8. Disengage the 2 hooks to remove the curtain shield airbag assembly.

9. Remove the 2 spacers from the curtain shield airbag assembly.