AIRBAG SYSTEM DATA LIST / ACTIVE TEST

Tech Tips

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

Note

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. DATA LIST FOR AIRBAG SENSOR ASSEMBLY

    1. Turn the ignition switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the Techstream on.

    5. Enter the following menus: Body Electrical / SRS Airbag / Data List.

    6. Check the values by referring to the table below.

      SRS Airbag
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Passenger Classification

      Passenger Classification/

      NG: Date is not determined

      Child: Child is seated or Vacant

      AF05: Adult is seated

      AM50: Adult is seated

      Fail: A failure is detected

      		 Child/AF05/AM50 -
      Left Side Buckle SW

      LH Side Buckle SW/

      Unset: The seat belt is not fastened

      Set: The seat belt is fastened

      NG: Data is not determined

      		 Unset/Set -
      Right Side Buckle SW

      RH Side Buckle SW/

      Unset: The seat belt is not fastened

      Set: The seat belt is fastened

      NG: Data is not determined

      		 Unset/Set -
      Display Type Information

      Display Type Information/

      LR: The display is indicated by LH/RH

      DP: The display is indicated by Driver/Passenger

      		 LR -
      Number of Past DTC

      Number of Past DTC/

      Min.: 0, Max.: 255

      		 0 -