ROOM LIGHT REMOVAL

  1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof)

    1. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws and remove the No. 1 room light lens.

      A011RO2E01
      Text in Illustration
      *1 Protective Tape
      *a Front

    2. Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws as shown in the illustration and remove the No. 1 room light housing.

      A011REHE01
      Text in Illustration
      *1 Protective Tape
      *a Front

    3. Using a screwdriver, disengage the 4 claws and disconnect the room light switch base from the No. 1 room light housing.

      A011U29E02
      Text in Illustration
      *1 Room Light Switch Base

  2. REMOVE SPOT LIGHT ASSEMBLY (w/ Sliding Roof)

    1. Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws and remove the 2 spot light lenses.

      A011USAE01
      Text in Illustration
      *1 Protective Tape
      *a Front

    2. Using a screwdriver with its tip wrapped with protective tape and moulding remover, disengage the 2 claws <A>.

      A011USGE01
      Text in Illustration
      *1 Protective Tape
      *2 Claw <A>
      *3 Claw <B>
      *4 Claw <C>
      *a Front

    3. Disengage the 2 claws <B> and 2 claws <C>, and disconnect the spot light housing.

    4. Using a screwdriver, disengage the 8 claws and disconnect the 2 map light sub-assemblies from the spot light housing.

      A011RPXE01
      Text in Illustration
      *1 Map Light Sub-assembly