DOOR CONTROL RECEIVER INSTALLATION

INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

1. Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.

   

   Text in Illustration

   *1	Alignment Mark (Blue)

   Note

   After installation, check that the corners fit correctly.

INSTALL REAR SIDE SEATBACK ASSEMBLY RH

1. Engage the hook.

2. Install the rear side seatback assembly RH with the 2 bolts.

   Torque:

   18 N*m  { 184 kgf*cm, 13 ft.*lbf }

3. Connect the connector.

4. Connect the rear seat outer belt to the rear seat shoulder belt guide.

INSTALL REAR SEAT CUSHION LOCK HOOK

1. Engage the claw to install a new rear seat cushion lock hook.

   

   Note

   Rear seat cushion lock hooks must not be reused.

   Tech Tips

   Use the same procedure for the RH side and the LH side.

INSTALL REAR SEAT CUSHION ASSEMBLY

1. Place the rear seat cushion assembly in the cabin.

   Note

   Be careful not to damage the vehicle body.

2. Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

   

3. Confirm that the seat cushion is firmly installed.

   Note

   When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.