CLEARANCE WARNING ECU INSTALLATION

  1. INSTALL CLEARANCE WARNING ECU ASSEMBLY

    1. Engage the 2 claws to install the clearance warning ECU assembly.

  2. INSTALL ECU INTEGRATION BOX RH

    1. Install the ECU integration box RH with the 2 nuts and bolt.

      Torque:
      Bolt
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
      Nut
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect each connector.

  3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    1. Connect each connector.

    2. Engage the glove compartment light as shown in the illustration.

      A011SNP

    3. Engage the guide and 2 clips.

      A011UHZ

    4. Install the lower instrument panel sub-assembly with the 5 screws <C> or <D>.

  4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

      A011TQFE01

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

    4. Push in the lock to install the airbag connector.

    5. Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    1. Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  6. INSTALL FRONT PANEL GARNISH RH

    1. Engage the 3 claws, 2 clips and 8 guides to install the front panel garnish RH.

  7. INSTALL INSTRUMENT SIDE PANEL RH

    1. Engage the 3 guides.

    2. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.

      A011RD8

  8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    1. Align the alignment mark (White) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.

      A011SVYE01
      Text in Illustration
      *1 Alignment Mark (White)

      Note

      After installation, check that the corners fit correctly.

  9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  10. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSPECT SRS WARNING LIGHT

    Click here