INTUITIVE PARKING ASSIST SYSTEM CUSTOMIZE PARAMETERS

  1. CUSTOMIZE INTUITIVE PARKING ASSIST SYSTEM

    1. Customizing with the Techstream

      Note

      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.

      1. Connect the Techstream to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the clearance sonar main switch on.

      4. Turn the Techstream on.

      5. Enter the following menus: Body Electrical / Utility / Customize / Sensor

      6. Select the setting by referring to the table below.

        Warning
        Display Default Content Setting Relevant ECU
        Rr Sensor Onset Range Wide Sets the buzzer activation range for the rear center sensors.

        Narrow or Wide

        • Narrow: 600 mm (23.6 in.)

        • Wide: 1000 mm (39.4 in.) (Pole)

        • Wide: 1500 mm (59.1 in.) (Wall)

        		 Clearance warning ECU assembly
        Keep Sense Buzzer Avail Sounds the buzzer when the distance between the vehicle and obstacle does not change for more than 3 seconds.

        Not Avail or Avail

        • Not Avail: Not Available

        • Avail: Available

        		 Clearance warning ECU assembly
        Fr & Rr Buzzer Volume H Changes the buzzer volume setting.

        L, M1, M2, M3 or H

        • L: Low volume

        • M1: Medium low volume

        • M2: Medium volume

        • M3: Medium high volume

        • H: High volume

        		 Clearance warning ECU assembly
        Sensor
        Display Default Content Setting Relevant ECU
        Sensor Condition N Avail Makes the front sensors available when the shift lever is in N.

        Not Avail or Avail

        • Not Avail: Not Available

        • Avail: Available

        		 Clearance warning ECU assembly
        Reverse Range Front Sensor F Changes the operation setting for the front sensors when the shift lever is in R.

        F or F Stop

        • F: Front sensors are available

        • F Stop: Front sensors are not available

        		 Clearance warning ECU assembly
        Non P/R Range Rear Sensor R Stop Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R.

        R, Rcrn or R Stop

        • R: All rear sensors are available

        • Rcrn: Rear corner sensors are available

        • R Stop: All rear sensors are not available

        		 Clearance warning ECU assembly