NAVIGATION SYSTEM (for Radio and Display Type) Data Signal Circuit between Stereo Jack Adapter and Extension Module

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the extension module via this circuit.

WIRING DIAGRAM

A011QZFE05

INSPECTION PROCEDURE

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (EXTENSION MODULE - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

    1. Disconnect the extension module connector.

    2. Disconnect the No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      A011SI2E45
      Standard Resistance
      Tester Connection Condition Specified Condition
      I146-2 (UDO-) - I175-2 (UDO-) Always Below 1 Ω
      I146-3 (UDO+) - I175-3 (UDO+) Always Below 1 Ω
      I146-5 (UJSS) - I175-5 (USG1) Always Below 1 Ω
      I146-2 (UDO-) - Body ground Always 10 kΩ or higher
      I146-3 (UDO+) - Body ground Always 10 kΩ or higher
      I146-5 (UJSS) - Body ground Always 10 kΩ or higher
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Extension Module)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here