NOISE FILTER ON-VEHICLE INSPECTION

  1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light)

    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      A011QU6E01

      Note

      Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      • Ignition switch off

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 10 kΩ or higher
      1 - 3 10 kΩ or higher
      1 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      2 - Body ground

      • Ignition switch ON

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 Below 1 V
      3 - Body ground Below 1 V
      2 - Body ground

      • Ignition switch ON

      • High mounted stop light on

      • Window defogger on

      • Luggage compartment room light on

      		 11 to 14 V
      3 - Body ground 11 to 14 V
      Text in Illustration
      *a Radio Setting Condenser

  2. INSPECT RADIO SETTING CONDENSER (for Window Defogger)

    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      A011SGGE01
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (+B) - 2 (GND)

      • Ignition switch off

      • High Mounted Stop Light off

      • Window Defogger turned off

      • Luggage compartment room light off

      		 10 kΩ or higher
      3 - Body ground Below 1 Ω
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Ignition switch ON

      • High Mounted Stop Light off

      • Window Defogger turned off

      • Luggage compartment room light off

      		 10 kΩ or higher
      1 - Body ground

      • Ignition switch ON

      • High Mounted Stop Light on

      • Window Defogger turned on

      • Luggage compartment room light on

      		 Below 1 Ω
      Text in Illustration
      *a Radio Setting Condenser