AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

A011S9SE20

INSPECTION PROCEDURE

Note

After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

PROCEDURE

  1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

    1. Measure the voltage according to the value(s) in the table below.

      A011RZ0E07
      Standard Voltage
      Tester Connection Condition Specified Condition
      I69-1 (MUTE) - Body ground

      Ignition switch ACC, audio system playing

      → Changing modes

      Above 3.5 V

      → Below 1 V
      Text in Illustration
      *a

      Component with harness connected

      (Stereo Component Amplifier Assembly)
    NG

    CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

    1. Disconnect the radio and display receiver assembly connector.

    2. Disconnect the stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I134-7 (MUT1) - I69-1 (MUTE) Always Below 1 Ω
      I134-7 (MUT1) - Body ground Always 10 kΩ or higher
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)

    1. Reconnect the stereo component amplifier assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      A011SVFE35
      Standard Voltage
      Tester Connection Condition Specified Condition
      I134-7 (MUT1) - Body ground Ignition switch ACC, audio system is playing Above 3.5 V
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Radio and Display Receiver Assembly)
    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here

    OK

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here