AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

A011TGSE01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY, BODY GROUND)

    1. Disconnect the radio and display receiver assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for 6 Speakers
      Tester Connection Condition Specified Condition
      I152-7 (GND1) - Body ground Always Below 1 Ω
      for 10 Speakers
      Tester Connection Condition Specified Condition
      I134-20 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      for 6 Speakers
      Tester Connection Condition Specified Condition
      I152-4 (+B1) - I152-7 (GND1) Always 11 to 14 V
      I152-3 (ACC1) - I152-7 (GND1) Ignition switch ACC 11 to 14 V
      I155-1 (IG) - I152-7 (GND1) Ignition switch ON 11 to 14 V
      for 10 Speakers
      Tester Connection Condition Specified Condition
      I134-1 (+B1) - I134-20 (GND1) Always 11 to 14 V
      I134-11 (ACC1) - I134-20 (GND1) Ignition switch ACC 11 to 14 V
      I155-1 (IG) - I134-20 (GND1) Ignition switch ON 11 to 14 V
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here