FRONT SPEED SENSOR REMOVAL

Tech Tips

  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.

  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL

  4. REMOVE FRONT FENDER LINER

    Tech Tips

    Use the same procedure for the LH side and RH side Click here.

  5. REMOVE FRONT SPEED SENSOR

    1. Disconnect the connector and disengage the clamp.

      A011SRI

    2. Remove the bolt and front speed sensor clamp from the body.

      A011TMH

    3. Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.

      A011QXQE01
      Text in Illustration
      *1 Front Speed Sensor Clamp
      *2 Front Flexible Hose

    4. Disengage the clamp from the front shock absorber assembly.

    5. Remove the bolt and front speed sensor from the steering knuckle.

      A011UA6

      Note

      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.