VALVE BODY ASSEMBLY INSPECTION

INSPECT SHIFT SOLENOID VALVE SL

1. Measure the resistance according to the value(s) in the table below.

   

   Text in Illustration

   *a	Component without harness connected (Shift Solenoid Valve SL)

   Standard Resistance
   Tester Connection Condition Specified Condition Solenoid Connector - Solenoid Body 20°C (68°F) 11 to 15 Ω

   • If the result is not as specified, replace the shift solenoid valve SL.

2. Connect a battery positive (+) lead to the terminal of the solenoid valve connector, and a negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating sound.

   Note

   When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

   OK
   Valve moves and makes an operating sound.

   • If the result is not as specified, replace the shift solenoid valve SL.

INSPECT SHIFT SOLENOID VALVE SLT

1. Measure the resistance according to the value(s) in the table below.

   

   Text in Illustration

   *a	Component without harness connected (Shift Solenoid Valve SLT)

   Standard Resistance
   Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 5.0 to 5.6 Ω

   If the result is not as specified, replace the shift solenoid valve SLT.

2. Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.

   Note

   When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

   OK
   Valve moves and makes an operating sound.

   If the result is not as specified, replace the shift solenoid valve SLT.

INSPECT SHIFT SOLENOID VALVE SLU

INSPECT SHIFT SOLENOID VALVE SL1

INSPECT SHIFT SOLENOID VALVE SL2

INSPECT SHIFT SOLENOID VALVE SL3

INSPECT SHIFT SOLENOID VALVE SL4