CRUISE CONTROL SYSTEM Cruise Main Indicator Light Circuit

DESCRIPTION

• The ECM turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

• The cruise control indicator light illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator light changes to amber (w/o multi-information display), or the cruise control indicator light goes out and a warning message is displayed (w/ multi-information display).

• The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

   1. Connect the Techstream to the DLC3.

   2. Turn the ignition switch to ON.

   3. Turn the Techstream on.

   4. Select the following menu items: Body Electrical / Combination Meter / Active Test.

   5. Check the cruise control indicator light by performing the Active Test.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise control indicator light	Cruise control indicator light (illuminated in green) ON / OFF	-
      Cruise Indicator*	Cruise control indicator light	Cruise control indicator light (illuminated in amber) ON / OFF	-

      *: w/o Multi-information Display

      OK
      The cruise control indicator light goes on or off.

   NG

   REPLACE COMBINATION METER ASSEMBLY Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here