PURGE VALVE REMOVAL

  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      A011RX1

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  2. REMOVE PURGE VSV

    1. Disconnect the connector and wire harness clamp.

      A011ROM

    2. Disconnect the 2 fuel vapor feed hoses.

    3. Remove the bolt and purge VSV.

      A011TH4