REAR CRANKSHAFT OIL SEAL INSTALLATION

  1. INSTALL ENGINE REAR OIL SEAL

    1. Apply MP grease to a new engine rear oil seal lip.

      A011U91E03
      Text in Illustration
      *1 Retainer
      *a

      Oil seal tap in depth

      (-0.5 to 0.5 mm)

    2. Using SST and a hammer, tap in the engine rear oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil seal tap in depth
      -0.5 to 0.5 mm (-0.0196 to 0.0196 in.)

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    1. Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. Install the front drive plate spacer.

      A011SAL

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

      A011QXLE03
      Text in Illustration
      *1 Drive Plate
      *2 Rear Spacer
      A011T1X Transaxle Side

    5. Apply adhesive to 2 or 3 threads of each bolt.

      A011VBME12
      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    6. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      A011QSIE01
      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here