REAR CRANKSHAFT OIL SEAL INSTALLATION

  1. INSTALL REAR ENGINE OIL SEAL

    1. Apply MP grease to the lip of a new oil seal.

      Note

      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      A011TX0E01
      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note

      • Keep the lip of the oil seal free from foreign matter.

      • Do not tap in the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    1. Using SST, hold the crankshaft.

      A011UYYE04
      SST
      09213-54015
      91551-80650
      09330-00021

    2. Clean the bolts and their installation holes.

    3. Install the front drive plate spacer.

      A011V1H

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. Install the drive plate and rear drive plate spacer onto the crankshaft.

      A011TWKE03
      Text in Illustration
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      A011T1X Transaxle Side

    5. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.

      A011SPVE03
      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    6. Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

      A011T88E01
      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here