AIR FUEL RATIO SENSOR REMOVAL

  1. REMOVE COOL AIR INTAKE DUCT SEAL

    1. Remove the 7 clips and cool air intake duct seal.

      A011RCO

  2. REMOVE V-BANK COVER SUB-ASSEMBLY

    1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      A011RX1

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

    1. Disconnect the air fuel ratio sensor connector.

      A011SIO

    2. Separate the wire harness clamp.

      A011TFU

    3. Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

      A011QTZE01
      SST
      09224-00010

  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here.

  5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

    1. Disconnect the air fuel ratio sensor connector.

      A011SB4

    2. Disconnect the harness clamp.

    3. Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

      A011RM7E01
      SST
      09224-00010