CRANKSHAFT POSITION SENSOR INSTALLATION

  1. INSTALL CRANKSHAFT POSITION SENSOR

    1. Clean and degrease the threads of the bolt for the crankshaft position sensor.

    2. Apply a light coat of engine oil to the O-ring of the sensor.

      A011QPCE07
      Text in Illustration
      *1 O-ring

    3. Apply adhesive to 2 or 3 threads of the bolt.

      A011SPVE06
      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

    4. Install the sensor with the bolt.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

      Note

      Make sure that the O-ring is not cracked or does not jump out of position during installation.

    5. Connect the sensor connector.

  2. INSPECT FOR OIL LEAK