KNOCK SENSOR INSTALLATION

Perform "Inspection After Repair" after replacing the knock control sensor Click here.

1. INSTALL KNOCK CONTROL SENSOR

   1. Install the sensor with the bolt so that the sensor is angled as shown in the illustration.

      

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Text in Illustration

      *a	Front of Engine
      *b	Up
      *c	7°
      *d	10°

      Note

      The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.

      Tech Tips

      Perform "Inspection After Repair" after replacing the knock control sensor Click here

   2. Connect the sensor connector.

2. INSTALL INTAKE MANIFOLD

   Click here