THROTTLE BODY REMOVAL

  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  3. REMOVE ENGINE UNDER COVER LH

  4. REMOVE ENGINE UNDER COVER RH

  5. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap sub-assembly.

      A011QSBE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

  6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      A011TUX

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    1. Disconnect the vacuum switching valve assembly from the air cleaner hose.

      A011R8H

    2. Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.

      A011T0H

    3. Separate the fuel vapor feed hose from the air cleaner hose.

      A011ROD

    4. Disconnect the ventilation hose from the cylinder head cover.

      A011U69

    5. Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.

      A011ROA

    6. Release the 2 clamps and remove the air cleaner cap sub-assembly.

      A011TFP

  8. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

    1. Disconnect the fuel tube from the clamp.

      A011SCP

    2. Disconnect the throttle body connector.

    3. Disconnect the water by-pass hose from the throttle with motor body assembly.

      A011T49

    4. Disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.

    5. Remove the 4 bolts and throttle with motor body assembly with fuel tube bracket.

      A011TBO

    6. Remove the bolt and fuel tube bracket.

      A011T4R

    7. Remove the gasket from the intake manifold.

      A011QNG