AUTOMATIC TRANSAXLE SYSTEM MANUAL SHIFTING TEST

  1. PERFORM MANUAL SHIFTING TEST

    Tech Tips

    • Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

    • If any abnormalities are found in the following test, the problem is in the transaxle itself.

    1. Disconnect the connector from the wiring harness connector.

      A011U0R

      Tech Tips

      It is possible to deactivate the electrical shift control by disconnecting the harness connector. The gears can then be changed mechanically with the shift lever.

    2. Drive with the harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

      Shift Lever Position Gear
      P P
      R R
      D

      3rd

      No Shift (Gears will not change)

    3. Connect the connector to the wiring harness connector.

    4. Clear the DTCs Click here.