TCM INSTALLATION

  1. INSTALL TCM

    1. Install the TCM to the automatic transaxle assembly.

    2. Install and tighten the 2 bolts in the order shown in the illustration.

      A011SB2E01
      Torque:
      11 N*m  { 115 kgf*cm, 8 ft.*lbf }

    3. Connect the connector to the TCM.

      A011QO0

    4. Turn the lock lever and secure the connector with the lock lever.

  2. INSTALL INLET NO. 1 AIR CLEANER

    1. Install the inlet No. 1 air cleaner to the intake air resonator sub-assembly.

      A011SE2

    2. Engage the pin to the radiator support.

  3. INSTALL BATTERY TRAY

  4. INSTALL BATTERY

    1. Install the battery and battery tray.

    2. Install the battery clamp with the bolt and nut.

      Torque:
      Bolt
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }
      Nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    3. Connect the positive (+) cable to the positive (+) battery terminal.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    1. Install the air cleaner case sub-assembly to the inlet No. 1 air cleaner.

      A011TV6E01

    2. Insert the projection of the air cleaner case sub-assembly to the hole of the No. 2 air cleaner bracket as shown in the illustration.

      Text in Illustration
      *1 Air Cleaner Case Sub-assembly
      *2 Inlet No. 1 Air Cleaner
      *a Projection
      *b Hole

    3. Tighten the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    4. Connect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

  6. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    1. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly with the hose clamp.

    2. Install the air cleaner cap with hose to the air cleaner case with the 2 clamps.

    3. Connect the wire harness clamp and mass air flow meter connector.

    4. Connect the 3 hoses.

    5. Connect the ventilation hose.

    6. Connect the mass air flow meter connector and wire harness clamp.

  8. INSTALL INLET NO. 2 AIR CLEANER

    1. Install the inlet No. 2 air cleaner to the air cleaner case sub-assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect the 2 wire harness clamps and vacuum hose clamp.

  9. INSTALL COOL AIR INTAKE DUCT SEAL

    1. Install the cool air intake duct seal with the 7 clips.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. CHECK AUTOMATIC TRANSAXLE SYSTEM

    Note

    If automatic transmission parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.