ВЫКЛЮЧАТЕЛЬ ЗАЖИГАНИЯ ПРОВЕРКА


  1. INSPECT ENGINE SWITCH

    A0157DXE09
    Text in Illustration
    *a

    Component without harness connected

    (Engine Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
      2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher
      7 (SS1) - 5 (GND) Pushed Below 1 Ω
      2 (SS2) - 5 (GND) Pushed Below 1 Ω

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

      Tech Tips


      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.


      • If the voltage is too low, the indicator will not illuminate.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 11 (SWIL)

      Battery negative (-) → Terminal 5 (GND)

      		 Illuminates (illumination of lettering)

      Battery positive (+) → Terminal 12 (INDS)

      Battery negative (-) → Terminal 5 (GND)

      		 Illuminates (green)

      Battery positive (+) → Terminal 13 (INDW)

      Battery negative (-) → Terminal 5 (GND)

      		 Illuminates (amber)
      A0158ETE74
      Text in Illustration
      *a

      Component without harness connected

      (Engine Switch)

      		 - -

      If the result is not as specified, replace the engine switch.