СТАРТЕР ПОВТОРНАЯ СБОРКА


  1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    1. A015D1G

      Apply high-temperature grease to the areas of the starter pinion drive lever indicated in the illustration.

      Text in Illustration
      A015DIT High-temperature grease

    2. Install the starter pinion drive lever and rubber seal to the starter center bearing clutch.

    3. Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal to the starter drive housing.

    4. A0156MG

      Apply high-temperature grease to the planetary gears and pins of the starter center bearing clutch.

      Text in Illustration
      A015DIT High-temperature grease

    5. Install the 3 planetary gears.

  2. INSTALL STARTER ARMATURE ASSEMBLY


    1. Install the starter armature to the starter yoke.

      Note

      The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.

  3. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    1. A0159T2

      Push out the 4 brushes from the brush holder so that they are held in place by the springs as shown in the illustration.

    2. A015B69

      Install the brush holder to the starter armature and push in the 4 brushes.

      Note

      Check that the positive (+) lead wires are not grounded.

    3. A0156EVE09
      Text in Illustration
      *1 Grommet
      *2 Negative Side
      *3 Positive Side

      Insert the grommet between the positive side and negative side.

  4. INSTALL STARTER YOKE ASSEMBLY


    1. A015C74E02
      Text in Illustration
      *1 Key A
      *2 Key B

      Install the starter armature plate to the starter yoke.

      Note

      Install the starter armature plate so that the keyway is positioned between key A and key B.

    2. Install the commutator end frame with the 2 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
    3. A0155CTE02
      Text in Illustration
      *1 Keyway
      *2 Key

      Align the key of the starter yoke with the keyway located on the starter drive housing.

    4. Using a T25 "TORX" socket wrench, install the 2 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  5. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    1. A0155M2

      Apply high-temperature grease to the plunger hook.

      Text in Illustration
      A015DIT High-temperature grease

    2. Hang the plunger of the magnet starter switch onto the drive lever from the upper side.

    3. Install the magnet starter switch with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    4. Connect the lead wire to the magnet starter switch with the nut.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }