ТОПЛИВНЫЙ НАСОС УСТАНОВКА


  1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.

    2. A0158D8E02
      Text in Illustration
      *1 Protrusion
      *2 Groove
      A015DIT Front

      Install the fuel suction with pump and gauge tube into the fuel tank.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

      Tech Tips

      Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.

    3. Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer 1 complete turn by hand.

    4. A015B6RE01

      Set SST on the retainer.

      SST
      09808-14030

      Tech Tips


      • Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket is not moved out of position.

      • Securely attach the claws of SST to the protrusions of the retainer and fix SST in place.

      • Install SST while pressing the claws of SST against the retainer (toward the center of SST).

    5. A015BV9E01

      Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.

      SST
      09808-14030

      Tech Tips

      Fit the tips of SST onto the ribs of the retainer.

  2. INSTALL FUEL TANK SUB-ASSEMBLY

    Click here