ТОПЛИВНЫЙ НАСОС СНЯТИЕ


  1. REMOVE FUEL TANK SUB-ASSEMBLY

    Click here

  2. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. A015B6RE01

      Set SST on the retainer.

      SST
      09808-14030

      Tech Tips


      • Securely attach the claws of SST to the protrusion of the retainer and fix SST in place.

      • Install SST while pressing the claws of SST against the retainer (towards the center of SST).

    2. A015BTR

      Using SST, loosen the retainer.

      SST
      09808-14030

      Note


      • Do not use any tools other than those specified in this operation. Damage to the retainer or the fuel tank may result.

      • While pressing down on SST so that the claws of SST do not slip off the protrusion of the retainer, turn the retainer counterclockwise to loosen it.

      Tech Tips

      The protrusion of the retainer fit in the ends of SST.

    3. Remove the retainer while holding the fuel suction tube assembly by hand.

    4. Remove the gasket from the fuel tank.