РЕГУЛЯТОР ДАВЛЕНИЯ В ТОПЛИВНОЙ СИСТЕМЕ УСТАНОВКА

INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
1. Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator.
  Note
  
  Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
  
  When inserting the injector, be careful not to damage the O-ring.
2. While turning the pressure regulator left and right, install it to the delivery pipe.
3. Install the 2 bolts.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
4. Connect the vacuum sensing hose to the pressure regulator.
5. Connect the No. 2 fuel tube to the pressure regulator Click here.
INSTALL AIR CLEANER HOSE ASSEMBLY
1. Text in Illustration
  
  *1 Groove
  
  *2 Protrusion
  
  Install the air cleaner hose so that the protrusion of the air cleaner cap aligns with the groove of the hose as shown in the illustration.
2. Tighten the 2 clamps.
  
  Torque:
  
  2.5 N*m { 25 kgf*cm, 22 in.*lbf }
3. Connect the vacuum hose.
4. Connect the No. 2 ventilation hose.

Text in Illustration
*1	Groove
*2	Protrusion

INSTALL V-BANK COVER SUB-ASSEMBLY

Обозначения на рисунке
*1	Кронштейн
*2	Крепежный крюк
*3	Штифт
*4	Уплотнительная шайба

Совместите 2 крюка крышки V-образного двигателя с кронштейном. Затем совместите 3 уплотнительных шайбы декоративной крышки V-образного двигателя с 3 штифтами и нажмите на декоративную крышку V-образного двигателя, чтобы закрепить штифты.

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT FOR FUEL LEAK
1. Connect the intelligent tester to the DLC3.
2. Turn the engine switch on (IG) and intelligent tester main switch on.
  
  Note
  
  Do not start the engine.
3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
4. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.