ДАТЧИК УРОВНЯ ТОПЛИВА В СБОРЕ (для расширительного топливного бачка) СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    Click here

  4. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    Click here

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY


    1. for Face to Face Seat Type:

      Remove the rear No. 2 seat assembly Click here.

    2. except Face to Face Seat Type:

      Remove the rear No. 2 seat assembly Click here.

  6. REMOVE REAR FLOOR MAT ASSEMBLY

    A015DLY

    1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

      Tech Tips

      Fold back the floor mat so that the rear No. 7 air duct can be removed.

  7. REMOVE REAR NO. 7 AIR DUCT


    1. A0158O5

      Detach the 4 clips and remove the air duct.

  8. REMOVE REAR FLOOR SERVICE HOLE COVER

    A015BX5

  9. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A015ACB

      Disconnect the sender gauge connector.

    2. Remove the 5 screws and sender gauge.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    3. Remove the gasket from the sender gauge.