БЛОК ЦИЛИНДРОВ ЗАМЕНА


  1. REPLACE STRAIGHT PIN

    Note

    It is not necessary to remove the straight pin unless it is being replaced.


    1. Remove the straight pins.

    2. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

      A0155OLE04
      Text in Illustration
      *A Upper Side *B Front Side
      *C Lower Side *D Rear Side
      Standard Protrusion
      Item Pin Diameter Specified Condition
      Pin A 10 mm (0.394 in.) 23 mm (0.906 in.)
      Pin B 10 mm (0.394 in.) 11 mm (0.433 in.)
      Pin C 8 mm (0.315 in.) 9 mm (0.354 in.)
      Pin D 4 mm (0.157 in.) 6 mm (0.236 in.)