ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note


      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  2. INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR


    1. Install the sensor protector with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL NO. 2 ENGINE UNDER COVER


    1. Установите защиту картера двигателя № 2 и закрепите ее 2 болтами.

      Torque:
      29 Н*м  { 296 кгс*см, 21 фунт-сила-фут }